Replacing your shower hose is not that hard

The shower hose has to be changed once at least every two years. The segment found in the hose is a great place where sediments can accumulate and lime deposits can build up. Other sediments filtered by the shower head can also build up within the hose. When the time comes when the shower head will not be able to filter the water flowing in, people could be bathing in dirty water.

Replacing a shower hose does not require a professional handy man, or a plumber. People can do it themselves easily with the use of simple tools and a new hose. There are only simple steps to get through the procedure.

Before the replacing process, people will need to find a compatible hose to take the place of their existing hose. This is also the chance for people to find a better hose to replace the old one they had. But a complete change of the type of hose used may require a change of shower head as well. Hose will not function well if it is not compatible with the shower head so people have to decide if they want a partial or complete replacement.

There are other materials needed for replacing the hose for the shower. People will need steel wool, pliers, a rag, duct tape, and Teflon tape.

The first step is to make sure that the work area will be dry throughout the process. It will be difficult to work on wet surfaces. In order to keep the shower area from getting wet, secure the controls of the shower the duct tape. This will prevent the switch from moving if it gets hit unintentionally.

The next step is to remove the hose from the shower head and the faucet. Using the pliers, slowly loosen up the nut connecting the hose to the shower head first. Do this with care as to prevent any damages that the pliers may cause the hose. The shower head will still be used so people have to take extra care of it.

After the shower head has been detached, the next step is to detach the shower hose completely from the faucet again using the pliers.

The next step is to clean out the old Teflon tapes completely from the faucet where the hose is attached. It will be impossible to attach the new hose tightly if there are remnants of the old tapes. Cleaning will be easier using the steel wool. Scrub out the remaining old tapes unlit the sticky surfaces left by the tapes are removed.

With new Teflon tape, wrap the ends of the faucet where the hose is to be connected, and the ends of the hose. Make sure that they are wrapped neatly without lumps. Connect the hose to the faucet, tightening both ends tightly. Secure the connection using the pliers to turn the nut and tighten.

Repeat the process to connect the shower hose to the shower head. Secure and tighten the same way the hose was connected to the faucet. The last step is to remove the duct tape from the switch of the faucet and turn it on. Observe the flow of water from the shower head and check any leaks from the hose.